Cheetah Raiders in 2014, 2.2 (4RB3 engine, modified Dongming Brothers independent ignition kit), electronic four-wheel drive, this is my big toy.
At the beginning of 2018, I took my family up the mountain to see the snow scenery. The mountain was steep and the road was slippery. I got out of the car and twisted the front axle lock, and the car slid down. Fortunately, no accident happened. Every time I think about it, I break out in a cold sweat. Perhaps the super-selected four-wheel drive is the kingly way. However, the 2.2 change to super-selection has been delayed due to the cumbersome process, complicated installation, and busy work.
One day when I was wandering in the circle of friends, I suddenly found this message from Brother Dongming:
Isn’t this exactly what I want? It doesn’t need to be so troublesome to change the super-selected four-wheel drive. It can be done by directly changing the shaft head. I saw the words of Brother Dongming: It is easy to use, and there is no problem after long-term use. So what else to say, it’s over if you just set it up.
Three days later, the goods arrived. Call the modification shop of the brothers directly, and go with the automatic shaft head~
This is my big toy
This is the manual shaft head to be replaced today~~~~~
Open it directly~~~
Removed shaft cover~~~~
Then remove the shaft head lock~~~~~~~
Remove the shaft head lock, the inside is really dirty, it is horrible~~~~
Start to clean up the dirty things~~~~~
After some cleaning, it is finally clean~~~~~~~~
How should I install it? Call Brother Dongming~~~~So I have the following tutorial~~~~~
The first step~~~~During installation, the circlip must be stuck in place~~
The second step~~~~ There are these two things on the position of the shaft head, so there is no replacement~~~
The third step~~~~~~
During the connection with Brother Dongming, I kept reminding about important things. In the third step, you must align the raised card slot and install it in place, otherwise it will make a rattling sound when running, and it will also cause damage to the automatic shaft head lock.
Follow the steps~~~~~ Add butter at the same time~~~~~
Apply butter and prepare for the convex groove~~~~
“Are you right?” “Don’t worry, it’s absolutely right!!!” “Are you sure?” “I’m sure!!!” “If, just in case……” “Don’t worry , I’ll pay you if you break it!!”
Ever since, it was installed like this. The left side is changed, and the right side is changed~~~ Under the repeated pats of the chest of the boss of the men’s maintenance center, Mr. Zhong, noisy, singing and laughing, installed the automatic shaft head lock. Start, hang the four-wheel drive, go~~~~~~ I can’t feel whether the four-wheel drive is in or not~~~~~~ The indicator light is on at 4H. “I didn’t hear the abnormal noise, but I don’t know if it’s hung up or not.” Boss Zhong and I, you look at me, I look at you, what should we do? This is done, it seems impossible to verify whether the installation is successful without climbing up the slope~~~~ Go, get in the car, find a place, and meet a construction site on the road, opposite is a retaining wall, the slope is about 30 degrees, so what else? What, let’s face the blast~~~
The first time I used the two-wheel drive to get on directly, fell down, put on the high-speed four-wheel drive 4H, and then got on again. At the end, it fell halfway, and then used the low-speed four-wheel drive 4L, and then got on again. The slope can be seen from the departure angle of the front and rear of the car. The effect is quite good. Boss Zhong operated the whole process and called directly. Who said that the 2.2 is not powerful, who said this is not good~~ Not bad, really good~~~
So far, the automatic spindle lock is installed successfully.
Here, I would like to express my special thanks to Brother Dongming who provided the automatic shaft lock. I would also like to thank him for his off-site technical guidance, and also thank him for the independent ignition system developed at no cost. The power improvement is really good, and the quality is really good.
At the same time, I would like to thank the onlookers: Da Mao and Cui Shen accompanied and witnessed the ramp~~~~
The film is over!
[The content comes from the off-road e family community]
Author: shuzongc
Link: http://bbs.ucar.run/thread_14759731_1_1.html
